How to Reset KM in BMW FEM BDC Module with VVDI2

September 27, 2017 Thomas Reid bmw-key-programmer

— (0)

Here’s the engineer solution to reset KM in BMW FEM/BDC module by Xhorse VVDI2 BMW key programmer.

Mileage calibration in BMW FEM BDC Guide:

Credit to harkan.pl

Procedure:

Open VVDI2 software

Select BMW

Select Key Learn->FEM/BDC Key Learn->Get Key Info
vvdi2 will read vehicle info, VIN, type etc

Select Programming FEM/BDC system

VVDI2 will show main 5 steps to program:

Step 1:
1.Read FEM/BDC coding via OBDII or on the bench
2. You’d better not close this window after start the procedure.

Step 2:
1.Open FEM/BDC shell, find 95128/95256 chip position, read EEPROM dump via VBDC programmer
2. Load original EEPROM dump and save special eeprom dump, write special eeprom dump back to 95128/95256 chip
3. Restore FEM/BDC shell, provide +12v and connect OBD

Step 3:
1. This operation require FEM/BDC on the bench, and make sure you inish step1 and steo2
2. Provide +12v to FEM/BDC and connect OBD

Step 4:
1.Open FEM/BDC shell,write original EEPROM dump (read in step2) back to 95128/95256 chip
2. Restore FEM/BDC shell, provide +12v and connect OBD
Step 5:
Load coding file read in step1, write to FEM/BDC via OBDII, finish FEM/BDC programming

Now here’s the detail instruction:
Click Backup Coding

Save coding file

VVDI2 prompt: Open FEM/BDC shell, read EEPROM dum,p via BDM programmer, press OK to view the
95128/95256 chip position

Check the chip position

Step 2 will start:Press OK to load original 95128/95256 EEPROM dump file

Dissolder the 95256 MCU chip and and read eeprom dump with Xhorse vvdi prog programmer

in VVDI prog, select M95256 chip type to read
Save eeprom data and name it 95256.ori

Click OK to load 95256.ori file write the service eeprom dump file to 95128/95256 chip
Press OK

name file 95256.ori_NEW

Step 3: will start make sure you finish the following operation:
1. Read and save coding file,write service eeprom dump file
2. Provide +12v to FEM/BDC and connect OBD
Continue?

Open 95256.ori_NEW

Click Write Tab

Write data

Dissolder chip from VVDI Prog programmer and solder it back to FEM/BDC shell
Press YES in VVDI2
updating system in progress

Step 4 will start:
1. Open FEM/BDC shell, write original eeprom dump (read in step2)
back to 95128/95256 chip
2. Restore FEM/BDC shell, provide +12v and connect OD

Continue after finish the list operation

Dissolder the 95256 chip from FEM/BDC shell, read original dump eeprom dump (read in step2) bac to 95256 chip with vvdi progmmaer