Skip to content
Key Programmer

    Autel IM608 BMW FEM Programming Failed, Restore EEPROM Data Solution

    bmw-key-programmer
    — (0)

    Problem:
    I tried to renew this BMW F30 FEM module with Autel IM608 after I modified the m95126 eeprom when I go to process the ECU it fails at the end and the issue becomes non-responsive bricked.

    Error “Programming failed, restore the EEPROM data to prevent loss of version information”

    Any solution?

    Autel Im608 BMW FEM F30 Fail To Process Ecu 1

    Autel Im608 BMW FEM F30 Fail To Process Ecu 2

    Autel Im608 BMW FEM F30 Fail To Process Ecu 3

    Solution:

    1st try upgrade to flash supported version !

    2nd special function ecu erasure, will delete everything on fem, renew as new, write vin and isn, program keys on car via OBD.

    Go to System Selection->Immobilizer->FEM/BDC Immobilizer->Special function->ECU erasure reset.

    Autel Im608 BMW FEM F30 Fail To Process Ecu 4

    Autel Im608 BMW FEM F30 Fail To Process Ecu 5

    Autel Im608 BMW FEM F30 Fail To Process Ecu 6

    Autel Im608 BMW FEM F30 Fail To Process Ecu 7

    Autel Im608 BMW FEM F30 Fail To Process Ecu 8

    This function will erase immobilizer data storaged in ECU, after that FEM/BDC will restore original module status without immobilizer data.

    Network connection is required to perform this function.

    Autel Im608 BMW FEM F30 Fail To Process Ecu 9

    www.obdii365.com

     

    Rate this article — (0)