Skip to content
Key Programmer

Read BMW MG1CS201 Locked ECU ISN with Autel IM508 and Gbox3

Illustration for Read BMW MG1CS201 Locked ECU ISN with Autel IM508 and Gbox3
Bmw Key Programmer
— (0)

Tutorial: How to read BMW Bosch MG1/MD1 locked B48/B58 DME ECUs with Autel MaxiIM IM508S/IM608 II.

ECU example: BMW B48 MG1CS201 locked TC298TP

autel-gbox3-read-bmw-mg1-locked-ecu-1

Tools required:

Autel IM608 II/IM508S+ XP400 Pro

Autel G-box3 with DB15 cable

12V power supply

 

NOTE: To read ISN from BMW DMEs, you must use Gbox3. G-box2 is not working.

autel-gbox3-read-bmw-mg1-locked-ecu-2

Procedure:

Go to System Selection- Engine- Direct Connection.

Input Bosch part number (i.e 0 261 S10 3GK) to detect ECU type: MG1CS201_LOCK TC298TP.

autel gbox3 read bmw mg1 locked ecu

Autel will show you the wiring diagram.

Check if the diagram is the same as your ECU.

autel-gbox3-read-bmw-mg1-locked-ecu-4

autel-gbox3-read-bmw-mg1-locked-ecu-5

Connect Gbox3 DB15 cable wires with DME ECU. Connect 5 wires, GND, CAN-L, CAN-H, 12V.

Then connect DB15 cable with g-box3.

Connect 12V power supply to the G-box.

autel-gbox3-read-bmw-mg1-locked-ecu-6

autel-gbox3-read-bmw-mg1-locked-ecu-7

autel-gbox3-read-bmw-mg1-locked-ecu-8

Then read EEPROM and Flash.

EEPROM data contains the ISN code.

If need to read ISN code, upload eeprom data to retrieve pin code.

autel-gbox3-read-bmw-mg1-locked-ecu-9

If need a full data backup, read eeprom and Flash separately. Then write data.

Rate this article — (0)