BMW EWS 4.3, 4.4 IC Adaptor for AK90,Xprog,R270

BMW EWS-4.3 & 4.4 IC Adaptor (No Need Bonding Wire) is designed to read & write data dump from EWS Immobilizer. The BMW EWS adapter can be used to work with Xprog, AK90 and R270 programmers without soldering any wires, just on board.

 

EWS 4.3 & 4.4                 9S12(2L86D)                              On board reading Adaptor

bmw-ews-ic-adaptor-for-x-prog-or-ak90-and-r270-programmer-1

Package lists: main hardware, longer cable, short cable, small circuit board

bmw ews ic adaptor for x prog or ak90 and r270 programmer 1-1

(before reading , please use “ sand paper “ to scrape glue off the circuit in back of EWS)

bmw ews ic adaptor for x prog or ak90 and r270 programmer 2-2

Working with AK90 key programmer:

Must be with the small circuit on reading:

bmw ews ic adaptor for x prog or ak90 and r270 programmer 3-3

Select “ 2L86D” under AK90 software

 

bmw ews ic adaptor for x prog or ak90 and r270 programmer 4-4

bmw ews ic adaptor for x prog or ak90 and r270 programmer 5-5

Working with Xprog M ECU programmer:

No need of the small circuit on reading

bmw ews ic adaptor for x prog or ak90 and r270 programmer ak90-6

Select “MC9S12-EEPROM-secured” family under “MCU/MPU” in the software

Working with R270 BDM programmer

Must be with the longer cable

bmw ews ic adaptor for x prog or ak90 and r270 programmer 6-7

Select “ 2L86D” under the selection of software and select reading “ EPROM or FLASH” as you wish

bmw ews ic adaptor for x prog or ak90 and r270 programmer 7-8

Rating
( No ratings yet )
Like this post? Please share to your friends: