Cloning DST Transponder by using Tango Key Programmer



Cloning DST Transponder by using Tango Key Programmer
Rate this post

Here is the tutorial on cloning DST Transponder by using original Tango key programmer.

 

Note: The document is only for education purpose. You can check the instruction on original website scorpio-lk as well.

Currently only Toyota and Yamaha keys are supported.For more details, Toyota supported keys have the 1-st page from the following set:
X0
X2
X3
X4*

X4*-only european market supported.

 


Cloning DST Transponder by Tango:
Run the Clone Mode selecting the appropriate menu item:

The next screen will appear:

Place an original key on the Tango and click “Read original key” button

Once the TIRIS DST or DST+ transponder detected the “Decode Transponder” button appears:

Click the “Decode Transponder” button. Tango software will prompt to to decode transponder:

Tango transponder programmer will run the decoding process:


In case the decoding finishes successfully the “Write Clone” button will appears:

Now,remove the original key and replace it with EH2 (battery emulator) or TPX2 transponder. You are all set to make a clone. Click “Write Clone” button and Tango will do it.

How to use Tango Key Programmer to Clone DST Transponder

Be the first to comment

Leave a Reply

Your email address will not be published.


*


This site uses Akismet to reduce spam. Learn how your comment data is processed.