Lonsdor K518ISE Read Audi Q7 PIN and Program Smart Key by OBD

Lonsdor K518ISE auto key programmer successfully program a smart key on an Audi Q7 post 2009 by OBD.  Same procedure goes to  Audi A6/A6L.

Step 1:  Read Immo data

Connect K518ISE host with vehicle via diagnostic socket

Select Immobilizer->Audi->A6L->2009 up->Immobilization

select Backup Immo data

Turn ignition switch to ON position
Lonsdor K518 host yellow indicator flashes
Reading immo data

K518 read Audi VIN, CS and PIN

save immo data as bin format and confirm

Backup data success


Step 2: Program Key

Select Learn key

All keys need to learn, otherwise will not start car.
Recommend to learn original car key first and then learn new key (smart key must be installed with battery)

select bin file
Again k518ise display VIN, CS and PIN information

select key number to program
Turn ignition switch to ON position

Follow Lonsdor K518ISE key programmer instruction to insert key and turn ignition ON

After all keys have been replaced, click OK to finish key learning.

Program key success.

Be the first to comment

Leave a Reply

Your email address will not be published.


This site uses Akismet to reduce spam. Learn how your comment data is processed.