How to use Toyota G and H chip OBD remote key programmer

There is a new OBD device that can program Toyota G and H chip (4D/67/68/72(G)) car transponder directly via OBD diagnostic socket. No software, laptop or other accessories required. No need to take parts from vehicles.


Add transponder key or remote for Toyota vehicle with Toyota G and H (4D/67/68/72(G)) chip. Not for all key lost.


Vehicle coverage:

1996-2015 Toyota cars with H or G chip

Successfully test on a 2015 Toyota Camry


obd remote programmer g h chip 2 300x300-1


How to use Toyota G and H chip OBD remote key programmer?

Easy 5 steps:

Step 1:

Get in the car and close the door. Insert the original key and turn switch ignition to “ON” position.


Step 2:

Switch to “ADD TRANSPONDER” and insert the key programmer device into OBD connector. You will hear two beep sound (Dee-Dee), it will start to add the remote.

Toyota G chip OBD device 2-3

Step 3:

After two beep sound, you will hear continuously beep sound, the device indicator light will flash during the procedure.

Toyota G chip OBD device 3-4

Step 4:

After the sound (Dee- Dee-),open the door, when hear the sound blaring. Press “Lock & unlock” key at the same time. And press the “lock” key. If the blaring ends, it’s OK.

Toyota G chip OBD device 4-5

Insert the new transponder, no need to turn it, the indicator light will turn into flash.

Step 5:

The indicator will turn off after 60 seconds, then it’s done.

Toyota G chip OBD device 5-6

The Toyota G OBD programmer now is available in for cheap US$34.99 free shipping to all over the world.

1 Comment

Leave a Reply

Your email address will not be published.


This site uses Akismet to reduce spam. Learn how your comment data is processed.